Sunbeam 44 Cutter
Sunbeam 44 Cutter for sale | 13.40m (44'0") | 1995 | 1x diesel 48hp | GRP Construction | Fin underwater profile | 6 berths | Boat REF# 152735
This boat has been sold but here are some boats that are still For Sale
|Designer||J & J Yachtdesign|
Phuket / Thailand
Get quote for boat deliveries
|Fuel capacity||245.0 ltr (53.9 G) Total - 1 Tanks|
|Water capacity||550.0 ltr (121.0 G) Total - 1 Tanks|
|Holding tank capacity||100.0 ltr (22.0 G) Total - 2 Tanks|
|Engine||1 x Diesel 48hp|
|Engine make and model||Yanmar 4JH2E (1995)|
|Engine Hours||engine1: 3600|
|Prop(s)||3 Blade folding (+ Rope Cutter)|
|Fuel consumption (approx)||2.5 ltr (0.6 G) /hour At Cruising Speed|
|Cruising speed (approx)||5 knots|
|Max speed (approx)||7.5 knots|
4 x 100 A/h House batteries.
1 x 100 A/h engine start battery.
|Draft Min||2.00m (6'7")|
|Draft Max||2.00m (6'7")|
RigCrusader Sails - 10% discount on rigging and spars!
Cutter rigged Aluminium spars (1995) with stainless steel standing rigging (1995)
SailsDiscounts available from our Preferred Partners
|Mainsail||Lee - Inmast (2008)|
|Headsail||Rolly Tasker - Furling (2011)|
|Other sails||Furling Staysail (2004)|
Mainsail: 52qm Try radial Genoa: 52qm (new 2011). Staysail: 23qm. Harken Furling system for all sails. Gennaker: 125 qm with cover, Spinnaker Pole, Boomvang, Back stay tensioner.
12 volt, 5 batteries charged by: engine, solar panels, shore power
Construction10% discount on ultrasonic antifouling
The hull is built in solid laminate in the hand lay up method and moulded in one piece. It is reinforced in the keel and collision areas in keeping with German Lloyd regulations. The deck is sandwich construction with aluminium reinforcement laminated under deck fittings. The hull to deck join is bolted, laminated and covered with an aluminium rubbing strake with a replaceable plastic insert strip.
Fin & bulb lead keel
|Total # of berths||6|
|No. of double berths||2|
|No. of single berths||2|
|Heads||2 heads (Manual)|
|Manual water system|
|Pressurised water system|
Forward is head / shower No1 then moving aft is full width cabin with double and two singles + storage, next aft is the saloon, with the engine situated below the center cockpit, the galley is to port with access through to spacious aft double cabin. Opposite the galley on the starboard side is the chart table then head / shower No2 with access from saloon and aft cabin.
2 burner gas cooker
Pactor II Pro, Forward looking sonar, Ham radio.
2 halyard winches
4 sheet winches
Electric windlass (with remote control)
(Bugel / Bruce / Danforth)
80.00m (262'6") of chain
Windpilot Pacific II windvane self-steering system
2.6m dinghy (2004)
8hp outboard, Yamaha 2 Stroke, Short Shaft (2009)
10mm Niro chain
2 bilge pumps (1 manual / 1 Electric)
Liferaft & EPIRB require service.